Fault Correction; Replacement Parts - Franke AQUA109 2000090028 Notice De Montage Et De Mise En Service

13. Fault Correction

Fault
Water does not flow
Water flows conti-
nuously
Water flow too weak
If you are unable to correct a fault or if the fault is not described in the fault correction
section, please inform our customer service department!

14. Replacement Parts

Bezeichnung
1 Sensor module*. . . . . . . . . . . . . . . 85-100-17.290
2 Solenoid valve 24 V DC . . . . . . . . 2000104454
* When placing an order, please specify the fitting-ID!
Die fitting ID is marked on the rear of the sensor
module.
8
Cause
– Voltage supply interrupted
– Water supply interrupted
– Sensor module faulty
– Solenoid valve faulty
– Solenoid valve dirty
– Solenoid valve faulty
– Supply pressure too low
– Water inflow not fully opened
Best.-Nr.
Remedy
➯ Restore it
➯ Restore it
➯ Replace it
➯ Replace it
➯ Clean it
➯ Replace it
➯ Check it
➯ Open it