Ice Maker And Storage Bin - Whirlpool W10913497D Guide D'utilisation Et D'entretien

The Dispenser Drip Tray
The drip tray can be removed to carry to the sink to empty
or clean.
Lift up on the front edge of the tray and pull forward to
■
remove.
The drip tray can also slide out during Measured/Favorite Fill.
■
!
Replace
Filter
Order Filter Door
! Ajar
!
!

Ice Maker and Storage Bin

IMPORTANT: To avoid low ice production and poor quality ice,
flush the water system before turning on the ice maker. See the
"Water and Ice Dispensers" section.
Following installation, allow 24 hours to produce the first
■
batch of ice. Discard the first three batches of ice produced.
Allow 2 to 3 days to fill the ice storage bin.
The quality of your ice will be only as good as the quality
■
of the water supplied to your ice maker. Avoid connecting
the ice maker to a softened water supply. Water softener
chemicals (such as salt) can damage parts of the ice maker
and lead to poor quality ice. If a softened water supply
cannot be avoided, make sure the water softener is operating
properly and is well-maintained.
If the ice in the storage bin clumps together, break up ice
■
using a plastic utensil and discard. Do not use anything sharp
to break up the ice. This can cause damage to the ice bin and
the dispenser mechanism.
Do not store anything in the ice storage bin.
■
28
a1 oz = b1 L
"#$#! a2 oz = b2 L !
Calibration
a3 oz = b3 L
! !
!
Dispense
!
!
%&#'#(')!"#$# !
!
Ice Maker in the Refrigerator
The ice maker is located on the left door behind the bins. Ice
cubes are ejected into the ice storage bin located on the left-
hand refrigerator door.
Turn the Ice Maker On/Off
1. Push up on the latch on the left-hand side of the ice
compartment to open the door.
2. Turn on the ice maker by moving the switch to the On (I)
position.
NOTES:
To manually turn off the ice maker, move the control to the
■
Off (O) position.
Your ice maker has an automatic shutoff. The sensor will
■
automatically stop ice production if the storage bin is full,
if the door is open or the storage bin is removed. The
control will remain in the On (I) position.
3. Close the ice compartment door.
Remove and Replace the Ice Storage Bin
Remove the ice storage bin by inserting your fingers into the
■
hole at the base of the bin and pulling the latch to release the
bin from the compartment. Lift the storage bin up and pull it
straight out.
Replace the storage bin inside the ice compartment and push
■
down to make sure it is firmly in place.
Ice Production Rate
The ice maker should produce approximately 3.2 lbs (1.5 kg)
■
of ice per day under normal operation.
To increase ice production, select the "Fast Ice" feature
■
from the control panel. The ice maker should produce
approximately 4.2 lbs (1.9 kg) of ice per day. See the "Tools"
section.