Preparation Before Operation - Mitsubishi Electric MSC-A07YV Notice D'utilisation

NAME OF EACH PART
Remote controller
Signal transmitting section
Operation display section
ON/OFF (operate/
stop) button
Open the front lid.
(This diagram shows an overall view.)
Fan speed control button
Operation select button
ECONO COOL
ECONO COOL button
RESET button
4
˚C
CLOCK
AMPM
AMPM
TOO TOO
ON/OFF
WARM COOL
Temperature buttons
AMPM
AMPM
TOO TOO
ON/OFF
WARM COOL
FAN STOP
I FEEL COOL
Off-timer button
VANE START
HEAT
DRY
/FAN On-timer button
MODE HR.
HR.button
MIN.button
MIN.
(Time set buttons)
RESET CLOCK
CLOCK set button
Vane control button

PREPARATION BEFORE OPERATION

Auto restart function
I
These models are equipped with an auto restart function. If you do not want to use this function,
please consult the service representative because the setting of the unit needs to be changed.
Auto restart function is ...
When the indoor unit is controlled with the remote controller, the operation mode, the set temperature and the fan speed are
stored in the memory. If a power failure occurs or the main power is turned off during operation, "Auto restart function" sets
automatically to start operating in the same mode as the one set with the remote controller just before the shutoff of the main
power. (Refer to page 6 for details.)
Indoor unit
I
Insert the power supply plug into the power outlet and/or turn the breaker on.
WARNING:
Remove dirt from the power supply plug and insert the plug securely.
If dirt adheres to the plug or insertion is incomplete, it may cause a fire or an electric shock.
Remote controller
How to set the type
I
This remote controller setting needs to be switched according to the type of air conditioner (COOL
& HEAT or COOL ONLY).
If the setting is incorrect, the air conditioner does not operate normally. Therefore, check if the
setting corresponds to the type of your air conditioner. If it does not, correct the setting as shown
below.
Slide switch
Type COOL & HEAT COOL ONLY
Position of the
slide switch