Publicité
Les langues disponibles
Les langues disponibles
1
2
3
4
► 1. Angle head 2. Hole for adjusting grip 3. Ring
4. Scale 5. Adjusting grip 6. Hole for adjusting grip
7. Yellow line 8. Compression spring
5.
Use an optional adjusting grip to adjust the fastening
torque. Insert the pin of the adjusting grip into the hole
in the front of the tool. And then, turn the adjusting
grip clockwise to set a greater fastening torque, and
counterclockwise to set a smaller fastening torque.
6.
Align the edge of the adjusting ring with your
desired number on the fastening torque scale.
7.
Insert the battery cartridge and be sure that a fas-
tening torque has been set up by using a fastening
torque tester.
8.
Rotate the ring so that the hole for adjusting grip is
covered, hold and then secure the ring with screw.
NOTE:
•
Numbers on the fastening torque scale is a
guideline to set up your desired fastening
torque.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Selecting correct socket
There are different types of sockets for some models
depending on applications. Choose and install a correct
socket for your application.
Installing or removing socket
5
1
2
6
3
7
8
► 1. Socket 2. Hole 3. Pin
To install the socket, push it onto the square drive of the
tool with one hand by depressing a pin on the square
drive with another hand until it locks into place. To
remove the socket, simply pull it off depressing the pin
on the square drive.
OPERATION
Hold the tool firmly and place the socket over the bolt
or nut. Then switch the tool on. When the clutch cuts
in, the motor will stop automatically. Then release the
switch trigger.
NOTE:
•
Hold the tool with its square drive pointed
straight at the bolt or nut, or the bolt or nut will
be damaged.
Limits of fastening capacity
Use the tool within the range of the revolution angle up
to 360°. If you use the tool beyond the upper limit of this
range, the clutch does not work. And the tool cannot
deliver enough fastening torque (LEDA #A blinks in
purple slowly or lights up in purple).
10 ENGLISH
Publicité
