Before Requesting Service - Panasonic MC-V225 Manuel D'utilisation

BEFORE REQUESTING SERVICE

WARNING
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do
so could result in electric shock or personal injury from cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
PROBLEM
Cleaner will
not run.
Poor job of dirt
pickup.
Dust escapes
the paper bag.
Cleaner picks up
moveable rugs
or pushes too
hard.
Electric Shock or Personal Injury Hazard.
POSSIBLE CAUSE
1. Unplugged at wall outlet.
2. ON-OFF switch not turned on.
3. Tripped circuit breaker/blown
fuse at household service panel.
1. Full or clogged dust bag.
2. Broken belt.
3. Carpet height selector incorrect.
4. Clogged hose or nozzle.
5. Hose not inserted fully.
6. Worn agitiator.
7. Hole in hose.
8. Dust cover improperly installed.
9. Belt not installed on motor shaft.
1. Bag improperly installed.
2. Bag torn.
1. Wrong pile height setting.
POSSIBLE SOLUTION
1. Plug in firmly. Push ON-OFF
switch to ON.
2. Push ON-OFF switch to ON.
3. Reset circuit breaker or replace
fuse.
1. Change bag.
2. Replace belt.
3. Set in the correct position.
4. Clean hose or nozzle area.
5. Insert hose.
6. Replace agitator.
7. Replace hose.
8. Properly install dust cover.
9. Install belt on motor shaft.
1. Properly install bag.
2. Replace bag.
1. Adjust setting.
- 38 -