Publicité
Les langues disponibles
Les langues disponibles
Cleaning, Care & Maintenance
Defrost appliance at least every 3 months, more often if required.
Switch off and disconnect from the power supply before cleaning.
•
Clean the interior of the appliance as often as possible.
•
Do not use abrasive cleaning agents. These can leave harmful residues.
•
Clean the door seal with water only.
•
Always wipe dry after cleaning.
•
Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
•
Take care when cleaning the rear of the appliance. Sharp edges can cut.
•
A POLAR agent or qualified technician must carry out repairs if required.
Stainless Steel Care
To maintain the stainless steel exterior of your Polar item, please consider the following information:
Never:
•
Use abrasive Scourers or scrubbing pads, etc.
•
Use Chlorinated or acidic detergents
•
Allow anything e.g. food, dirt, cleaning chemicals to remain on the surface for longer than necessary,
clean them off right away.
•
Allow the surface to remain wet.
Do:
•
Clean often.
•
Use soft Cloths or plastic Scourers.
•
Rub with the grain of the metal, rather than across it.
•
Use detergents and polish designed for cleaning Stainless Steel.
•
Ensure that the cleaning products are washed off fully and that the steel is left dry.
Routine Maintenance
Condenser Cleaning
•
The condenser is part of the refrigeration system. The condenser requires monthly cleaning.
•
Always disconnect power supply before carrying out Routine Maintenance.
•
Failure to clean the condenser will reduce the performance and life of your Polar unit and may
invalidate your warranty
•
The condenser is located behind the service door on the right-hand side of the refrigeration cabinet.
•
These models have a removable filter which can be cleaned with a vacuum cleaner.
G377-G379_G596-G600_GD873-GD874_DL914-DL917_GL182-GL184_ML_A5_v4_170425.indb 5
UK
5
2017/4/25 10:07
Publicité
