Publicité
Les langues disponibles
Les langues disponibles
• Do not use the appliance in immediate vicinity of a bath tub, a shower or
a swimming pool (observe a minimum distance of 10 ft / 3 m). Place the
appliance such that a person in the bath tub cannot touch the appliance.
• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• If the supply cord is damaged, it must be replaced by the manufacturer, or
its service agent, or a qualified person in order to avoid a hazard.
• Prior to any maintenance, cleaning, servicing and after each use, switch
off the appliance and unplug the mains cable from the socket.
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician.
• Do not operate any fan with a damaged cord or plug. Discard fan or return
to an authorized service facility for examination and/or repair.
• Do not run cord under carpeting. Do not cover cord with throw rugs, run-
ners, or similar coverings. Do not route cord under furniture or appliances.
Arrange cord away from traffic area and where it will not be tripped over.
• This product employs overload protection (fuse). A blown fuse indicates
an overload or short-circuit situation. If the fuse blows, unplug the product
from the outlet. Replace the fuse as per the user servicing instructions
(follow product marking for proper fuse rating) and check the product. If
the replacement fuse blows, a shortcircuit may be present and the prod-
uct should be discarded or returned to an authorized service facility for
examination and/or repair.
Setting up / operation
1. After the «Q» fan has been placed in the desired position, connect the
mains cable (2) to the domestic supply socket.
2. Switch on the «Q» fan at the controller (4) and set the desired speed
(Positions 1 – 3, from gentle breeze to powerful circulation).
User Servicing Instructions
a) Grasp plug and remove from the receptacle or other outlet device. Do not
unplug by pulling on cord.
b) Open fuse cover. Slide open fuse access cover on top of attachment plug
towards blades.
c) Remove fuse carefully. Pull out the ends of the fuse from attachment
plug.
d) Risk of fire. Replace fuse only with 5 Amp, 125 Volt fuse.
e) Close fuse cover. Slide closed the fuse access cover on top of attach-
ment plug.
f) Risk of fire. Do not replace attachment plug. Contains a safety device
(fuse) that should not be removed. Discard product if the attachment
plug is damaged.
Publicité
