Troubleshooting; Repairs, Spare Parts - XciteRC Rocket 125 Mode D'emploi

Troubleshooting · Repairs
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!

Troubleshooting

Problem Possible Cause
Rotor don't move ON/OFF switch is OFF
Weak Quadrocopter battery
Transmitter - model not bound
Rotor stops sud- Weak Quadrocopter battery
denly, Quadrocop- Weak transmitter battery
ter chrashes
The Quadrocopter Gyro initialisation failure
does not react to
the remote control. Quadcopter not bound to the trans-
Loss of control. mitter
Gyro calibration failure after a crash
The Quadrocopter Gyro calibration failure after a crash
flies uncontrollably

Repairs, Spare Parts

Normal wear and defective parts that result from an accident, are excluded from the guarantee. These in-
clude in particular:
For car models: bald tires, worn parts and drive gears, or bent / broken suspension, chassis or bodywork
For ship models: damaged or broken propellers, torn superstructure
For airplanes: damage due to improper transportation or crash
I If you find a part that is defective in material or workmanship right after opening the package, return - before
you used it – to your dealer or directly to us and we will send you a replacement.
For the Rocket 125 3D some parts are available as spares. If a part is defective or worn, you can identify it
with the help of the online spare parts list.
In case of problems or questions, please contact your dealer or:
XciteRC Modellbau GmbH & Co. KG - Service, Autenbachstrasse 12, D-73035 Göppingen, Phone +49 7161
40 799 50
Email: service@xciterc.de
Spare parts for the XciteRC Rocket 125 3D you may order in your local hobby shop or online at http://www.
XciteRC Rocket 125 3D
Corrective Action
Switch ON Quadrocopter
Re-charge battery
Rebind: first switch on the model, then the
transmitter
Re-charge battery
Change transmitter batteries
Place the model on a flat surface when
switching on
Re-bind: switch on the quadcopter first,
then the transmitter
Re-calibrate the gyro, see section: Get-
ting Started, gyro calibration
Re-calibrate the gyro, see section Getting
Started, gyro calibration
EN
23