Landing; Maintenance; Troubleshooting; Corrective Action - XciteRC Rocket 250 3D Mode D'emploi

Landing:

• Carefully push the left throttle lever rearward. Try to land „smooth" without damaging the Quadrocopter.
EN • NOTE: if the flight battery runs empty, the Quadrocopter does not respond accurately to your com-
mands, the flight is unstable. In this case land immediately.
• Switch of the Quadrocopter and then the transmitter.
WARNING: the motor of the XciteRC Rocket 250 3D may get very hot during operation. Allow to cool
down minimum 20 minutes before the next start to avoid damage. Fire hazard!

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!

Troubleshooting

Problem
Rotor don't move
Rotor stops sud-
denly, Quadrocop-
ter chrashes
The Quadrocopter
does not react to
the remote control.
Loss of control.

Repairs, Spare Parts

Normal wear and defective parts that result from an accident, are excluded from the guarantee. These in-
clude in particular:
For car models: bald tires, worn parts and drive gears, or bent / broken suspension, chassis or bodywork
For ship models: damaged or broken propellers, torn superstructure
For airplanes: damage due to improper transportation or crash
22
Landing · Maintenance · Troubleshooting · Repairs
Possible Cause
ON/OFF switch is OFF
Weak Quadrocopter battery
Transmitter - model not bound
Weak Quadrocopter battery
Weak transmitter battery
Gyro initialisation failure
Another radio controlled device using
the same channel
Affected by sunlight or other strong
light

Corrective Action

Switch ON Quadrocopter
Re-charge battery
Rebind: first switch on the model, then the
transmitter
Re-charge battery
Change transmitter batteries
Place the model on a flat surface when
switching on
Switch off another/own device or move to
another spot
Avoid direct sunlight or other strong
light
XciteRC Rocket 250 3D