Troubleshooting; Repairs, Spare Parts - XciteRC Rocket 260 3D Quadrocopter Mode D'emploi

Troubleshooting · Repairs
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNiNG: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNiNG: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!

Troubleshooting

Problem Possible Cause
Rotor don't move ON/OFF switch is OFF
Weak Quadrocopter battery
Transmitter - model not bound
Rotor stops sud- Weak Quadrocopter battery
denly, Quadrocop- Weak transmitter battery
ter chrashes
The Quadrocopter Gyro initialisation failure
does not react to
the remote control. Quadcopter not bound to the trans-
Loss of control. mitter
Gyro calibration failure after a crash
The Quadrocopter Gyro calibration failure after a crash
flies uncontrollably

Repairs, Spare Parts

Normal wear and defective parts that result from an accident, are excluded from the guarantee. These in-
clude in particular:
For car models: bald tires, worn parts and drive gears, or bent / broken suspension, chassis or bodywork
For ship models: damaged or broken propellers, torn superstructure
For airplanes: damage due to improper transportation or crash
I If you find a part that is defective in material or workmanship right after opening the package, return - before
you used it – to your dealer or directly to us and we will send you a replacement.
For the Rocket 260 3D some parts are available as spares. If a part is defective or worn, you can identify it
with the help of the spare parts list at the end of this manual.
In case of problems or questions, please contact your dealer or:
XciteRC Modellbau GmbH & Co. KG - Service, Autenbachstrasse 12, D-73035 Göppingen, Phone +49 7161
40 799 50
Email: service@xciterc.de
XciteRC Rocket 260 3D
Corrective Action
Switch ON Quadrocopter
Re-charge battery
Rebind: first switch on the model, then the
transmitter
Re-charge battery
Change transmitter batteries
Place the model on a flat surface when
switching on
Re-bind: switch on the quadcopter first,
then the transmitter
Re-calibrate the gyro, see section: Get-
ting Started, gyro calibration
Re-calibrate the gyro, see section Getting
Started, gyro calibration
EN
23