Installation Of The Rotor Guards; Getting Started - XciteRC Rocket 125 Mode D'emploi

Installation of the rotor guards · Getting started
• Connect the USB cable to a PC or appropriate power supply with max. 1 A output. The red LED lights up.
• Connect the Quadrocopter battery with the charger.
• WARNING: The Quadrocopter battery is polarized. Check the side channels. Do not use force - fire
or explosion hazard!
• The red LED goes out to indicate charging. Charging time is about 40 minutes. If the battery is fully char-
ged, the red LED lights up again.
• Unplug the battery and the USB cable.
The flight time of the Quadrocopter is about 6-8 minutes.

Getting started

Before you begin please check:
• WARNING: Only start with a sufficiently full transmitter batteries (rechargeable batteries) and fully
charged drive battery – crash hazard!
• Check all parts for damage and dirt. Replace any damaged parts and clean the model, because dirt
increases the weight and therefore can degrade the flying qualities.
• Place into the battery compartment on the rear (1) and connect it to the quadrocopter (2).
• WARNING: The battery connector is polarized. Check the side channels. Do not use force - fire or
explosion hazard!
- LED flashing fast: automatic
detection
- LED flashing slowly: ready to
bind
- LED on: Binding completed
• Place the Quadrocopter on a flat surface in the starting position and switch it on (1). The LEDs first fla-
shes quickly, then after a few seconds slow. Now switch the transmitter on. Move the left throttle lever all
the way up and then back in the lowest position (2). This safety circuit prevents the rotor may start after
turning ON the Quadrocopter
• The model is ready to fly as soon as a short beep is heard. The POWER LED of the transmitter and the
Quadrocopters LED lights up solid.
• Note: when the model is not used for about 30 seconds, it automatically switches back to the bind
mode, the LEDs starts to flash. To fly, the throttle must once again moved all the way up and then back
in the lowest position
• GYRO CALIBRATION: before the first flight the gyro must be calibrated. Move both control levers
downwards to the left and hold until all LEDs flash briefly. This is also necessary if the model flies badly
e.g. after a crash
XciteRC Rocket 125 3D
1
1. First move up
1 2
2. Move down immediately
2
2
EN
19