Publicité
Les langues disponibles
Les langues disponibles
Fig. 13
Fig. 14
21. With the removed power head in an upside
down position, carefully remove the
cartridge filter
17
Fig. 15.
Fig. 15
22. Clean the cartridge filter
tapping or brushing dirt off.
23. If necessary, use a mild soap and water
solution to wash the cartridge filter
rinse with clean water. Allow the cartridge
filter to air dry for 24 hours before
installing onto the filter cage.
CAUTION:
NOT BE DONE INDOORS IN LIVING AREAS.
from the filter cage.
by gently
17
and
17
CLEANING SHOULD
FOR OPTIMAL PERFORMANCE A NEW
FILTER IS RECOMMENDED.
EMPTYING DRY WASTE FROM
THE TANK
WARNING:
POWER CORD IS DISCONNECTED FROM THE
OUTLET.
24. Disconnect the hose
Undo the latches
head
from the collection tank. Fig 16.
8
Place power head on soft, clean surface
upside down. Clear all dirt or debris from
the collection tank and hose. Place power
head back onto the collection tank and
secure latches.
Fig. 16
Wet Pick Up Operation
IMPORTANT! When vacuuming large quantities
of liquids, do not immerse the nozzle
completely in the liquid; leave a gap at the tip
of the nozzle opening to allow air inflow. The
machine is fitted with a float valve that stops
the suction action when the collection tank
reaches its maximum capacity. You will notice
an increase in motor speed.
WARNING:
HAPPENS, TURN OFF THE MACHINE,
DISCONNECT FROM POWER SUPPLY,
AND DRAIN THE LIQUID INTO A SUITABLE
RECEPTACLE OR DRAIN. TO CONTINUE
VACUUMING, REFIT THE COLLECTION
TANK WITH THE DRAIN CAP. AFTER WET
VACUUMING, TURN THE MACHINE OFF
AND REMOVE PLUG FROM POWER SUPPLY.
EMPTY THE COLLECTION TANK, CLEAN AND
DRY THE INSIDE AND OUTSIDE BEFORE
STORAGE.
ENGLISH
VERIFY THAT THE
from the vacuum.
12
and remove the power
4
WHEN THIS
9
Publicité
