Craftsman CMXEVCVVFB511 Manuel D'utilisation page 10

ENGLISH
NOTICE: The foam wet filter must be removed
after wet vacuuming and the cartridge filter
must be installed before dry vacuuming again.
FOAM WET FILTER INSTALLATION
AND CLEANING:
WARNING:
POWER CORD IS DISCONNECTED FROM THE
OUTLET.
25. Remove the power head and place in an
upside down position. Follow instructions
to remove the cartridge filter on page 8-9.
26. Carefully slide the foam wet filter
over the filter cage making sure the cage is
completely covered. Fig. 17.
Fig. 17
27. To remove the foam wet filter, place the
removed power head in an upside down
position, and carefully remove the foam
wet filter . Fig. 18.
19
Fig. 18
10
VERIFY THAT THE
down
19
28. Use a mild soap and water solution to
wash the foam wet filter
clean water. Fig. 19.
Fig. 19
29. Allow the wet filter to air dry for 24 hours
before installing onto the filter cage.
EMPTYING LIQUID WASTE FROM
THE TANK
WARNING:
POWER CORD IS DISCONNECTED FROM THE
OUTLET.
30. Disconnect the hose
31. Undo the latches
power head from the collection tank
8
. Place power head
6
surface upside down.
32. After use, empty the collection tank
clean and dry the inside and outside before
storage. Fig. 20.
Fig. 20
STORAGE
Before storing your vacuum, the collection
tank should be emptied and cleaned. The
accessories should be cleaned and stored
so they can be readily available when
needed. Store the wet/dry vacuum indoors.
and rinse with
19
VERIFY THAT THE
from the vacuum.
12
and remove the
4
on a soft, clean
8
6