Craftsman CMXEVCVVFB511 Manuel D'utilisation page 6

ENGLISH
2. Lift the power head
tank .
6
3. Remove the contents from inside the
collection tank
6
contents as listed on page 3.
ASSEMBLY
Handle Assembly
4. Insert the handle
on the top of the power head
it with the screws
tighten the screws. Fig. 1.
Fig. 1
Hose Storage Rack Assembly
5. Position the hose storage rack
front side of the power head, just above
the top edge of the tank, as illustrated in
Fig. 2. Squeeze the open sides of the hose
storage rack inward and insert the open
3
ends into the allocated slot. Verify that the
rack is secured in place as shown in
Fig. 3. Install the second rack in the same
way, ensuring it is secured. Fig. 2-4.
Fig. 2
6
off the collection
8
; make sure you have all
into the slots located
2
and secure
8
provided. Do not over-
10
on the
3
Fig. 3
Fig. 4
GENERAL SET UP
6. Your vacuum comes ready for dry vacuum
cleaning. If the cartridge filter is not
installed, refer to page 8 for installation
instructions.
7. For wet vacuum cleaning, remove the
cartridge filter, and install the supplied foam
wet filter. See page 10 for the foam wet
filter installation instructions.
8. Place the power head back on the collection
tank and secure into place using the latches.
9. Insert the larger end of the hose
vacuum port on the collection tank
lock into place. Fig. 5.
Fig. 5
10. Choose the desired accessory
and/or extension wand
the end of the hose
into the
12
and
6
13 14 15
and insert onto
11
. Fig. 6.
12