Craftsman CMXEVCVVFB511 Manuel D'utilisation page 8

ENGLISH
16. Before turning on the vacuum, firmly hold
onto the loose end of the hose. Plug the
power cord into the outlet. Turn the motor
on by flipping the switch to the 'I' ON
position.
WARNING:
COMPLETED BLOWING, FLIP THE POWER
SWITCH TO THE 'O' OFF POSITION AND
UNPLUG THE POWER CORD FROM THE
OUTLET.
FILTER INSTALLATION AND CLEAN
UP
Dry Pick Up Operation
NOTICE: Clean or change the filter regularly
for best performance. ALWAYS USE THE
CARTRIDGE FILTER FOR DRY VACUUMING. If
the machine is used without the cartridge filter,
the motor will burn out and the warranty will be
voided. Always keep spare filters on hand.
NOTICE: The filters included are made of high
quality materials designed to stop small dust
particles. The cartridge filter should be used
for dry pick-up only. A dry cartridge filter is
necessary to pick up dust. If the cartridge filter
is wet, it will clog quickly and be very difficult
to clean. Handle the filter carefully when
removing it for cleaning and replacing it. Check
the filters for tears or small holes. A small hole
can let dust pass through and out of the filter.
Do not use a filter with holes or tears; replace
it immediately.
INSTALLING AND CLEANING THE
CARTRIDGE FILTER:
WARNING:
POWER CORD IS DISCONNECTED FROM THE
OUTLET.
17. Remove the power head and place in an
upside down position.
18. Install the cartridge filter
cage making sure the cage is completely
covered. Fig. 10.
8
ONCE YOU HAVE
VERIFY THAT THE
over the filter
17
Fig. 10
19. Place the filter retainer
the cartridge filter
and tighten down by turning the retainer
clockwise; do not over-tighten. Fig. 11 &
12.
Fig. 11
Fig. 12
20. To remove the cartridge filter, unlock and
remove the filter retainer
retainer handle counter-clockwise. Fig. 13
& 14.
on the top of
18
over the raised lip
17
by turning the
18