Festool ETS EC 150/3 EQ Notice D'utilisation D'origine page 16

ETS EC 150
GB
In the event of a slowdown in performance or in-
creased vibrations, blow and clean cooling air
openings.
9.1 Cleaning the extraction channels
We recommend cleaning the extraction channels in
the machine [4-1] roughly once a week (particular-
ly if sanding synthetic resin, in the case of wet sand-
ing and if sanding plaster) using a small flat brush
or a cloth.
9.2 Cleaning the inside of the power tool
Regularly clean the inside of the power tool at the
bottom of the fan, [4-3] otherwise the vibration val-
ues worsen as a result of the dust accumulation.
9.3 Replace sanding pad and sanding pad
brake
The rubber sleeve[4-2] brushes off the sanding pad
and prevents uncontrolled turning of the sanding
pad. The sanding pad brake is almost wear-free
thanks to the pins used.
In the case of a decreasing braking effect, first
check the sanding pad for wear and replace it if
necessary. Replace damaged sanding pad brake/
rubber sleeve.
16
10 Accessories
Use only original Festool sanding pads. Low-quality
sanding and polishing pads may cause serious ma-
chine imbalances that decrease the quality of the
work results and increase wear on the power tool.
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
11 Environment
Do not dispose of electric power tools in house-
hold waste! Recycle devices, accessories and
packaging. Observe applicable country-specific
regulations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
Information on REACh: www.festool.com/reach