Modello - Modèle - Model
Modell - Modelo - Modelo
Fabbricante - Constructeur - Manufacturer
Hersteller - Fabricante - Fabricante
MUST BE CARRIED OUT BY THE AFTER-SALES SERVICE IN CHARGE OF INSTALLATION).
9. PRESCRIPTIONS AND RESTRICTIONS
KEEPING PHARMACEUTICAL PRODUCTS, GLASS BOTTLES OR FLASKS IN THE SHOWCASE IS
STRICTLY FORBIDDEN as they could get broken and entail a safety hazard (fig. 12).
DO NOT REMOVE COVERS OR PANELS WHEN IT REQUIRES THE USE OF TOOLS AND ESPECIALLY
DO NOT REMOVE THE ELECTRIC CONTROL BOARD COVER.
ATTENTION: The refrigerating system does not alter defrost water in any way, which is the product
of the steam contained in the air circulating inside the showcase. Defrost water and wash water
may nonetheless mix with pollutants deriving from the products preserved in the appliance, from
preservation means, from product remains, from the accidental crush of recipients containing li-
quids or from the use of improper detergents (see section 10 point 1).
THE WATER PRODUCED BY THE SYSTEM MUST THEREFORE BE DISPOSED OF THROUGH A SEWER
OR PURIFICATION SYSTEM IN COMPLIANCE WITH THE REGULATIONS IN FORCE.
DO NOT LEAN ON FRONT GLASS OF CABINET NOR REST ANY OBJECT OF ANY WEIGHT AGAINST
IT (EVEN BRIEFLY).
ANY OTHER USE NOT EXPLICITLY MENTIONED IN THIS BOOKLET MUST BE CONSIDERED
AS HAZARDOUS. THE MANUFACTURER DISCLAIMS ALL LIABILITY FOR ANY DAMAGE RE-
SULTING FROM IMPROPER, INCORRECT OR UNREASONABLE USE.
10. ORDINARY MAINTENANCE
ATTENTION! BEFORE MAINTENANCE OR CLEANING, DISCONNECT THE REFRIGERATOR FROM THE
ELECTRICAL POWER SUPPLY USING THE WALL MAIN CUTOFF SWITCH (fig. 17).
IMPORTANT: During maintenance or cleaning operations, be sure that the light in the working area
is sufficient. If necessary, use an additional source of light. Mind also the hot and moving parts
marked with the relevant symbol. The use of heavy-duty gloves is recommended.
CLEANING THE CABINET
1) Every week clean the outer surfaces of the display case with mild soap or detergent in lukewarm
water only. Wipe carefully with a soft cloth. Never clean it using inflammable or scouring agents
alcohol, acetone or solvents.
NEVER CLEAN THE DISPLAY CASE BY THE USE OF WATER JETS (fig. 13). Clean glass surfaces using
glass-cleaning products only. The use of water is not recommended here, as it may cause scale to
build up.
2) Every month clean the cabinet inside surfaces following the instructions provided in the prece-
ding item and those indicated here below:
• Disconnect the cabinet from the power mains by the wall main cutoff switch (fig. 17).
Those who carry out the maintenance work must constantly ensure that the cabinet is
not powered up again by other personnel.
• Empty the appliance, store its content in coldrooms or refrigerators that are adequate for keeping
the requisite preservation temperature.
• Wait until the display case has reached ambient temperature.
• Clean the appliance inside using mild soap in lukewarm water and then wipe carefully with a soft
cloth.
• After having carefully checked that the cabinet is completely dry, reassemble it and switch it on.
VELNSxx
DUALIO E - SV
EPTA Spa - Via Mecenate 86 - 20138 Milano - ITALY Tel.
+39 02 5540 3211
STATE REVISION
D
ORD.
DATE
20.04.21
PAGE:
N° DOC.
35/53
UM000443