Using Your Washer - Whirlpool W11339718A Guide D'utilisation Et D'entretien

USING YOUR WASHER

First wash cycle without laundry
Before washing clothes for the first time, set up the Load & Go™
bulk dispenser (on some models) or add detergent to the single-
dose dispenser (see the "Using the Dispensers" section). Choose
the Regular (what to wash) and Quick (how to wash) cycle and
run it without clothes. Use only HE detergent. This initial cycle
serves to ensure the interior is clean.
1.
Sort and prepare your laundry
Sort items by recommended cycle, water temperature, and
colorfastness. Separate heavily soiled items from lightly soiled.
Separate delicate items from sturdy fabrics. Treat stains promptly
and check for colorfastness by testing stain remover products on
an inside seam.
IMPORTANT:
■ Empty pockets. Loose change, buttons, or any small object
can plug pumps and may require a service call.
■ Close zippers, fasten hooks, tie strings and sashes, and
remove non-washable trim and ornaments.
■ Mend rips and tears to avoid further damage to items
during washing.
■ Turn knits inside out to prevent pilling. Separate lint-takers
from lint-givers. Synthetics, knits, and corduroy fabrics will
pick up lint from towels, rugs, and chenille fabrics.
■ Do not dry garments if stains remain after washing because
heat can set stains into fabric.
■ Always read and follow fabric care labels and laundry
product instructions. Improper usage may cause damage
to your garments.
2.
Add laundry products, if desired
Single-dose laundry packets, Oxi-type boosters, color-safe
bleach, or scented crystals can be added to the drum prior to
adding laundry. When using single-dose laundry packets, make
sure that the bulk dispenser is disabled (on some models) or off
(see the "Control Panel and Features" section).
NOTE: Always follow manufacturer's instructions.
13