Memory/My Comfort Operation - Toshiba RAS-B10SKVP-E Mode D'emploi

RASseries_OwnersManual.book Page 14 Tuesday, January 9, 2007 4:48 PM

MEMORY/MY COMFORT OPERATION

Use the MEMO button to store a frequently used operation setting for convenience.
Start the air conditioner in the operation mode that you want the remote controller to
store.
Press the button as shown below while the air conditioner is operating.
a MEMO button
Press this button briefly to ready for storing the setting.
All the icons currently shown flash, except for the clock time indicator and mode
indicator.
b MEMO button
Hold down the MEMO button for 3 seconds or more while the indicator flashes.
The mark is shown and the setting is stored.
• If you do not press the MEMO button within 3 seconds or if you press another button,
the MEMORY setting is cancelled.
• Operation modes which can be stored with the MEMO button are MODE, Temperature,
FAN, TIMER and Hi POWER.
To operate the air conditioner with the setting stored using the MEMO button.
a MY COMFORT button
Press the MY COMFORT button. The setting stored with the MEMO button will be
shown and the air conditioner operates based on the setting.
(A): When the MY COMFORT button is pressed while operation is stopped
• The OPERATION indicator (green) on the display panel of the indoor unit turns on, and
operation starts after approximately 3 minutes.
(B): When the MY COMFORT button is pressed during operation
• The operation mode changes to the setting stored with the MEMO button.
• Initial setting:
MODE : AUTO
Temperature : 22
EN
a
b
a
14