Timer Operation - Toshiba RAS-B10SKVP-E Mode D'emploi

RASseries_OwnersManual.book Page 12 Tuesday, January 9, 2007 4:48 PM

TIMER OPERATION

ON timer and OFF timer
Setting the ON Timer
a ON button
ON
Press the ON button. Set the timer to the desired time.
ON
Each time the ON button is pressed, the time changes in ten minute increments.
Holding down the ON button changes the time in one hour increments.
b SET button
SET
Press the SET button to set the timer.
SET
The timer time is displayed, and the timer starts.
c CLR button
CLR
Press the CLR button to cancel the timer setting.
CLR
Setting OFF Timer
a OFF
button
OFF
Press the OFF button.
OFF
Set the timer to the desired time.
Each time the OFF button is pressed, the time changes in ten minute increments.
Holding down the OFF button changes the time in one hour increments.
b SET button
SET
Press the SET button to set the timer.
SET
The timer time is displayed, and the timer starts.
c CLR
button
CLR
Press the CLR button to cancel the timer setting.
CLR
.
CAUTION
• When you select timer operation, the remote controller automatically transmits the timer signal to the indoor unit at the
specified time. Therefore, keep the remote controller in a location where it can transmit the signal to the indoor unit
properly.
• If you do not press the SET
Once you select timer operation mode, the settings are saved in the remote controller.
Thereafter, the air conditioner will start operating under the same conditions as you pressed the
controller.
You cannot set the timer when the clock display is flashing.
Follow the instructions in the section "Setting the clock" on page 6 to set the clock, and then set the timer.
EN
button within 30 seconds after setting the time, the setting will be cancelled.
SET
12
b
c
a
or button on the remote
ON OFF