Pure Operation - Toshiba RAS-B10SKVP-E Mode D'emploi

RASseries_OwnersManual.book Page 10 Tuesday, January 9, 2007 4:48 PM

PURE OPERATION

Press this button to start the electrical air purifying operation.
During air conditioner operation
a PURE button
PURE operation starts by pressing this button.
• The PURE indicator (blue) on the display panel of the indoor unit turns on.
• Plasma pure filter is activated.
To stop only PURE operation
PURE button
PURE operation stops by pressing this button.
• The PURE indicator (blue) on the display panel of the indoor unit turns off.
• Plasma pure filter is deactivated.
To stop air conditioner operation at the same time
button
Air conditioner operation and PURE operation stop by pressing this button.
• The OPERATION indicator (green) and PURE indicator (blue) on the display panel of
the indoor unit turn off.
CAUTION
• When the button is pressed the next time, operation starts with the combined
air conditioner and PURE operation.
• During the combined air conditioner and PURE operation, air conditioner operation
only cannot be stopped.
When the air conditioner is stopped
a PURE button
PURE operation starts by pressing this button.
• The PURE indicator (blue) on the display panel of the indoor unit turns on.
INFORMATION INFORMATION
• During PURE operation, a small amount of ozone is produced, and you might notice the smell.
• When the air flow is automatic, it changes between LOW
LOW operation is performed when the indoor air becomes clean. During operation, the position of the vertical air flow louvers may
change if the room temperature is low.
• Opening the air inlet grille during PURE operation sometimes turns on the FILTER indicator (orange).
In this case, stop PURE operation (stop the air conditioner if it is also operating), and then close the air inlet grille.
• The FILTER indicator (orange) turns on after PURE operation is performed for about 1000 hours.
When the indicator turns on, clean the plasma pure filter. () see page 21.)
EN
and MED+ .
10
a