Fitting The Blade Guard/Combination Guard, Grass Blade And Ball-Bearing-Mounted Support Cup; Fitting The Blade Guard And Saw Blade - Gardena FC2256 Manuel D'utilisation

Fitting the blade guard/
combination guard, grass blade
and ball-bearing-mounted
support cup
• Hang the trimmer guard/combination guard (A) on the
two hooks on the plate holder (M). Bend the guard
around the shaft and tighten it with the bolt (L) on the
opposite side of the shaft. Use the locking pin (C).
Place the locking pin in the groove on the screw head
and tighten. See diagram.
M
A
• CAUTION! Always use the recommended guard for
the cutting attachment you are using. See chapter on
Technical data.
• Fit the drive disc (B) on the angle gear's output shaft.
• Centre the metal cup (P) on the drive disc's blade
guide.
• Turn the output shaft until one of the holes in the drive
disk aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Position the blade (D) with the drive disk (B). Make
sure that the blade is centered by fitting it to the guide
on the drive disk.
• Fit the support flange (F) on the output shaft so that it
rests against the blade.
N
E
F
D
P
B
C
M L
• Screw the support cup (E) onto the output shaft
threads (CAUTION! Left-hand thread). Tighten to a
torque of 35-50 Nm (3.5-5.0 kpm). Use the socket
spanner in the tool kit. Note that the locking pin (C)
ASSEMBLY
L
C
A
must remain inside the gear housing to lock the drive
disk. Hold the shaft of the socket spanner as close to
the blade guard/combination guard as possible.
WARNING! Tighten the lock screw (N) in
!
the center hole of the support cup. Tighten
to a torque of 35-50 Nm (3.5-5.0 kpm),
CAUTION! Left-hand thread. If the lock
screw is not fitted in the support cup,
there is a risk that the support cup will
come unscrewed. This means that the
blade will also come loose, which could
result in serious or fatal injury to the
operator or others.
Fitting the blade guard and saw
blade
CAUTION! Always use the recommended guard for the
cutting attachment you are using. See chapter on
Technical data.
FC2256, FC2256W
• The blade guard (A) is fitted using 4 screws (L) as
shown.
L
A
English
–
55