Electrolux EOC5644BOK Notice D'utilisation page 31

Problem
The water in the cavity em‐
bossment does not boil.
The water comes out of
the cavity embossment.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
11.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service
centre is on the rating plate. The rating
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Possible cause
The temperature is too low. Set the temperature at
There is too much water in
the cavity embossment.
The demo mode is activa‐
ted.
plate is on the front frame of the
appliance cavity. Do not remove the
rating plate from the appliance cavity.
.........................................
.........................................
.........................................
ENGLISH
Remedy
least to 110 °C.
Refer to "Hints and tips"
chapter.
Deactivate the oven and
make sure that the appli‐
ance is cold. Wipe the wa‐
ter with a cloth or sponge.
Add the correct amount of
water to the cavity em‐
bossment. Refer to the
specific procedure.
1. Deactivate the oven.
2. Press and hold the but‐
ton .
3. The first digit on the
display and Demo indi‐
cator start to blink.
4. Enter the code 2468 by
pressing the buttons
or to change the
values and press
confirm.
5. The next digit starts to
blink.
6. Demo mode deacti‐
vates when you con‐
firm the last digit and
the code is correct.
31
to