Perel CSOLBF Mode D'emploi page 6

Installation
1.
2.
3.
4.
5.
Working Mode
1.
2.
3.
V. 01 – 02/04/2019
CSOLBF
Use the card to measure the position of the holes correctly.
Drill two holes.
Insert a nylon plug in each hole.
Insert a screw in the lower nylon plug and tighten slightly.
Insert the lower notch of the lamp onto the screw.
Straighten the lamp and fasten the upper screw.
Press the mode button to adjust the working mode.
Press the mode button once to enter mode A. This mode
automatically switches on to full brightness when a motion
has been detected. It switches to weak brightness for
10 seconds after the last motion detection.
Press the mode button twice to enter mode B. This mode
automatically switches on to full brightness when a motion
has been detected. It switches off 10 seconds after the last
motion detection.
Press the mode button three times to switch off the
appliance.
6 ©Velleman nv