Wiring Connection - Kenwood KDC-X302 Mode D'emploi

INSTALLATION/CONNECTION

Wiring connection

IMPORTANT : We recommend installing the unit with a commercially available custom wiring harness specific for
your car and leave this job to professionals for your safety. Consult your car audio dealer.
Antenna terminal
To front speaker (left)
To front speaker (right)
To rear speaker (left)
To rear speaker (right)
Car fuse box
Ignition switch
Car fuse
box
Battery
To the metallic body or chassis of the car
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
When connecting to an external amplifier, connect its ground wire to
the car's chassis to avoid damaging the unit.
Fuse (10 A)
If no connections are made, do not let the wire come out from the tab.
Brown
(Mute control wire)
Blue/White
(Power control wire/
Antenna control wire)
(12 V 350 mA)
Light blue/yellow
(Steering remote control
wire)
To connect the Kenwood navigation system, refer your
navigation manual
To the power control terminal when using the optional
power amplifier or to the antenna control terminal in
the vehicle
(For / /
/ /
/ )
To the steering wheel remote control adapter
(For )
To Kenwood Marine Remote Control unit (optional
accessory)
For the latest information on marine accessories, visit
<http://www.kenwood.com/usa/car/marine/>
ENGLISH
/
37