Bluetooth - Kenwood KDC-X302 Mode D'emploi

BLUETOOTH®
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
MIC (microphone input terminal)*
Rear panel
Adjust the
microphone angle
Secure using cord clamps
(not supplied) if necessary.
* /
Connect to the microphone input jack. ( 38)
Microphone (supplied)
/ / :
Pair and connect a Bluetooth device for the first time
1 Press to turn on the unit.
2 Search and select this unit model name (KDC-X3**/KDC-BT3**/KDC-BT3*/
KDC-BT2*/KDC-MP3**/KMR-D3**) on the Bluetooth device.
"PAIRING" "PASS XXXXXX" Device name "PRESS" "VOLUME KNOB"
appears on the display.
• For some Bluetooth devices, you may need to enter the Personal Identification
Number (PIN) code immediately after searching.
3 Press the volume knob to start pairing.
"PAIRING OK" appears when pairing is completed.
Once pairing is completed, Bluetooth connection is established automatically.
• / /
and/or "BT2" indicator on the faceplate lights up.
• / /
window lights up.
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered in the
unit even if you reset the unit. To delete the paired device,
• A maximum of two Bluetooth phones and one Bluetooth audio device can be
connected at any time.
However, while in BT AUDIO source, you can connect to five Bluetooth audio
devices and switch between these five devices. ( 22)
• Some Bluetooth devices may not automatically connect to the unit after pairing.
Connect the device to the unit manually.
• Refer to the instruction manual of the Bluetooth device for more information.
/ / : "BT1"
: "BT1" and/or "BT2" on the display
21, [DEVICE DELETE].
ENGLISH
17