Troubleshooting - Kenwood KDC-X302 Mode D'emploi

LEARNING STEERING REMOTE CONTROL
(for )
7
Press and hold any control keys on your steering remote
control which you want to assign.
A list of key functions will appear on the display.
NONE (default)/MUTE/SEEK UP/SEEK DOWN/VOL UP/VOL DOWN/
MODE/ON HOOK/OFF HOOK/VOICE/ENTER
8 Turn the volume knob to select a function to assign, then
press the knob.
The selected key function is assigned to the steering
remote control key you have selected in step 7.
The display returns to the key list as on step 5.
• K## (Function): When certain function has been assigned
to a key.
9 Repeat steps 6 , 7 and 8 to assign other control keys.
10 Press and hold to exit.
To reassign the control keys
1 Press repeatedly to enter STANDBY.
2 Press the volume knob to enter [FUNCTION].
3 Turn the volume knob to select [SYSTEM], then press the
knob.
4 Turn the volume knob to select [USER S.REMO], then press
the knob.
5
Turn the volume knob to select [RESET KEY], then press the
knob.
6
Turn the volume knob to select [YES], then press the
knob.
All the control keys will be reset.
Selecting [NO] will cancel the operation.
When [FACTORY RESET] is set to [YES] ( 5), it will also reset the
learning steering remote control.
To return to the previous setting item, press

TROUBLESHOOTING

Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING THEN PWR
ON" appears.
"PROTECTING SEND SERVICE" appears.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the display is
incorrect.
The unit does not work at all.
(For
"SET ERROR"/"DEL ERROR"
(For
"ERROR"/"FAIL"
• Radio reception is poor.
• Static noise while listening to the radio.
Disc cannot be ejected.
Noise is generated.
Tracks do not play back as you intended
them to play.
"READING" keeps flashing.
.
Elapsed playing time is not correct.
"LOADING" appears when you enter
search mode by pressing
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the terminals of
the speaker wires are insulated properly. Turn the power
on again.
Send the unit to the nearest service center.
Clean the connectors. ( 32)
Reset the unit. ( 3)
Setting/deleting the remote control ID is unsuccessful.
)
Turn the power off, then turn on the power and
perform the operation again.( 6)
Your steering remote controller is not compatible,
)
learning may not be completed. Consult your car audio
dealer for details.
Connect the antenna firmly.
Press and hold M to forcibly eject the disc. Be careful not
to drop the disc when it is ejected. If this does not solve
the problem, reset the unit. ( 3)
Skip to another track or change the disc.
Playback order is determined when files are recorded.
Do not use too many hierarchical levels or folders.
This is caused by how the tracks are recorded.
This unit is still preparing the iPod/iPhone music list. It
. may take some time to load, try again later.
29
ENGLISH