Panasonic EY7410 Instructions D'utilisation page 5

Symbol
V
n
0
Revolutions or reciprocations per
.../min
Ah
Electrical capacity of battery pack
WARNING!
Some dust created by power sanding, saw-
ing, grinding, drilling, and other construction
activities contains chemicals known to the
State of California to cause cancer, birth
defects or other reproductive harm. Some
examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks and cement
and other masonry products
• Arsenic and chromium from chemical-
ly-treated lumber.
To reduce your exposure to these chemi-
cals: work in a well ventilated area, and
work with approved safety equipment,
such as dust masks that are specially
designed to filter out microscopic particles.
III
. FOR BATTERY CHAR­
GER & BATTERY PACK
Important Safety Instructions
1) SAVE THESE INSTRUCTIONS -This
manual contains important safety
and operating instructions for battery
charger EY0L10.
) Before using battery charger, read all
instructions and cautionary markings
on battery charger, battery pack, and
product using battery pack.
3) CAUTION -To reduce the risk of injury,
charge only Panasonic Battery Pack as
shown in last page.
Other types of batteries may burst
causing personal injury and damage.
4) Do not expose charger and battery pack
to rain or snow.
EY7410(UL).indb 5
Meaning
Volts
Direct current
No load speed
minutes
Rotation only
- 5 -
5) To reduce risk of damaging the electric
plug and cord, pull by plug rather than
cord when disconnecting charger.
6) Make sure cord is located so that it
will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
7) An extension cord should not be used
unless absolutely necessary.
Use of improper extension cord could
result in a risk of fire and electric shock.
If extension cord must be used, make
sure that:
a. pins on plug of extension cord are
the same number, size and shape as
those of plug on charger.
b. extension cord is properly wired and
in good electrical condition.
c. wire size is large enough for ampere
rating of charger as specified below.
RECOMMENDED MINIMUM AWG SIZE OF
EXTENSION CORDS FOR
BATTERY CHARGERS
AC Input Rating. Amperes
Equal to or But less
greater than than
0 
8) Do not operate charger with damaged
cord or plug-replace them immediately.
9) Do not operate charger if it has received
a sharp blow, been dropped, or other-
wise damaged in any way; take it to a
qualified service personnel.
10) Do not disassemble charger; take it
to a qualified service personnel when
service or repair is required. Incorrect
reassembly may result in a risk of ele-
ctric shock or fire.
11) To reduce the risk of electric shock, un-
plug charger from outlet before attempting
any maintenance or cleaning.
1) The charger and battery pack are spe-
cifically designed to work together. Do
not attempt to charge any other cordless
tool or battery pack with this charger.
13) Do not attempt to charge the battery
pack with any other charger.
14) Do not attempt to disassemble the bat-
tery pack housing.
15) Do not store the tool and battery pack
in locations where the temperature may
reach or exceed 50°C (1°F) (such
as a metal tool shed, or a car in the
AWG Size of Cord
Length of Cord,
Feet
5 50 100 150
18 18 18 16
2006/09/08 17:30:49