Panasonic EY7410 Instructions D'utilisation page 9

[Battery Pack]
For Appropriate Use of Bat­
tery pack
Li­ion Battery pack (EY9L10)
• For optimum battery life, store the Li-
ion battery pack following use without
charging it.
• The ambient temperature range is
between 0°C (3°F) and 40°C (104°F).
If the battery pack is used when the
battery temperature is below 0°C
(3°F), the tool may fail to function
properly.
• When battery pack is not in use, keep
it away from other metal objects like:
paper clips, coins, keys, nails, screws,
or other small metal objects that can
make a connection from one terminal
to another.
Shorting the battery terminals togeth-
er may cause sparks, burns or a fire.
• When operating the battery pack,
make sure the work place is well ven-
tilated.
Battery Pack Life
The rechargeable batteries have a lim-
ited life. If the operation time becomes
extremely short after recharging,
replace the battery pack with a new
one.
Battery Recycling
ATTENTION:
FOR Li­ion Battery Pack, EY9L10
A Li-ion battery that is recyclable powers
the product you have purchased.
Please call 1­800­8­BATTERY for infor-
mation on how to recycle this battery.
EY7410(UL).indb 9
[Battery Charger]
Charging
Common Cautions for the Li­
ion/Ni­Cd Battery Pack
NOTE:
• When a cold battery (of about 0°C
or less) is to be charged in a warm
room, leave the battery in the room
for at least one hour and charge
it when it has warmed up to room
temperature. (Failing to do so may
result in less than a full charge.)
• Cool down the charger when charging
more than two battery packs consecu-
tively.
• Do not insert your fingers into con-
tact hole, when holding charger or
any other occasions.
CAUTION:
To prevent the risk of fire or damage
to the battery charger.
• Do not use power source from an
engine generator.
• Do not cover vent holes on the
charger and the battery pack.
• Unplug the charger when not in
use.
Li­ion Battery Pack
NOTE:
Your battery pack is not fully charg-
ed at the time of purchase. Be sure
to charge the battery before use.
Battery charger (EY0L10)
1. Plug the charger into the AC outlet.
NOTE:
Sparks may be produced when the
plug is inserted into the AC power
supply, but this is not a problem in
terms of safety.
. Slide the battery dock cover back to
allow insertion of the Li-ion battery
pack.
● Verify that the cover is locked se­
curely in place.
3. Insert the battery pack firmly into the
charger.
- 9 -
2006/09/08 17:30:54