Attach A Monitor To The Display Arm - StarTech ARMWALLDS Guide De L'utilisateur

Attach a monitor to the display arm

Warning! Attaching the monitor is a two-person job. Do not attempt to complete this
task by yourself.
To accommodate different monitor sizes, the ARMWALLDS comes with two sets of
screws that are different lengths and diameters.
To select the appropriate screws for the type of monitor that you're using, complete
the following:
• Determine the depth of the mounting holes on the monitor.
• Determine the diameter of the mounting holes on the monitor.
1. Line up the mounting holes on the display arm with the mounting holes on the
back of the monitor.
2. Insert the M4x14 mm screws or the M5x14 mm screws through the display arm
and into the back of the monitor.
3. Use a Phillips screwdriver to tighten the screws.(figure 2)
Warning! Do not over-tighten the screws. If you encounter resistance while you're
tightening the screws, stop tightening. Failure to do so could result in damage to the
monitor.
figure 2
Instruction manual
Display arm
M4x14 mm screw
M5x14 mm screw
6