VINCENT PHO-500 Manuel D'utilisation page 25

6. OUT: signal output to the amplifier
A pair of RCA input sockets of your system's
audio amplifier must be connected with these
output sockets.
7. GND: Ground clamp for the
record player
In addition to the stereo signal connection
cable most record players are equipped with
a grounding cable that can be recognized by
the cable lug at the end of the cable. This lug
has to be fitted to the clamp "GND".
8. DC IN: power supply input of
the PHO-500
Make a connection to the power supply output
(3) of the PHO-500ps using the supplied DIN
cable.
REAR VIEW
11
7
9
10
9. IN: signal input (MC/MM) from
the record player
The audio output (or as well an attached
audio cable) of the record player must be con-
nected to these input sockets
10. Fine adjustment mechanism (Bottom)
for MM/MC cartridges (more information on
page 29)
11. Voltage Selector:
The voltage selector behind the pane allows swit-
ching the voltage from 230 V to 110 V.
Refer to safety instructions for further information
(p. 29, "Switching the Voltage")
6
8
Vincent
25