Technical Data; Installation - Zanussi ZQA12430DA Notice D'utilisation

1. Remove the screw
from the lamp
cover.
2. Remove the lamp
cover (refer to the
illustration).
3. Replace the used
lamp with a new
lamp of the same
power and specifically designed for household ap-
pliances (the maximum power is shown on the lamp
cover).

Technical data

Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the energy
label.

Installation

Caution! Read the "Safety Information" carefully for
your safety and correct operation of the appliance
before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated in-
door (garage or cellar) also, but for optimum performance
install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on the
rating plate of the appliance:
4.
5.
6.
7.
Closing the door
1.
2.
3.
Height
Width
Depth
Climate
SN
N
ST
T
Electrical connection
Before plugging in, ensure that the voltage and frequency
shown on the rating plate correspond to your domestic
power supply.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the do-
mestic power supply socket is not earthed, connect the
Install the lamp cover.
Tighten the screw to the lamp cover.
Connect the plug to the mains socket.
Open the door. Make sure that the light comes on.
Clean the door gaskets.
If necessary, adjust the door. Refer to "Installation".
If necessary, replace the defective door gaskets.
Contact the Service Center.
815 mm
596 mm
550 mm
13 h
230-240 V
50 Hz
Ambient temperature
class
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
19