the central fastening ring.
•
Check and clean all nozzles.
•
Remove the rotating spray arm wash upper and lower (C-6), by removing the
axes of rotation.
•
Check and clean all nozzles.
•
Clean the tank thoroughly.
•
Replace all the elements by performing the opposite way.
•
Leave the door of the appliance opened when not in use.
•
Clean the external surfaces of the appliance with soap and water, then rinse
and dry thoroughly.
NOTE: Never use wood shavings, straw or wire brushes to clean stainless steel.
After a number of uses, more or less variable depending on the hardness of the water
used, the calcium salt and the magnesium present in the water can form on the internal
walls of the heating tank, pipes and the tank, a layer of scale; in the long run it can affect
the proper functioning of the device. It is therefore necessary to make periodic descaling
by qualified personnel. In case of dysfunction of the appliance, turn off power by
disconnecting the main switch and call a qualified service center.
Appliance idle
If not used for a long period of time, it is advisable for reasons of hygiene to do the
following steps:
•
fill the machine with water without detergent;
•
make a few cycles with an empty appliance;
•
drain it completely.
Repeat this sequence several times until the drained water is quite clean and free of
residue of dirt and detergent. In case of very long downtime, complete by protecting the
stainless steel surfaces with liquid paraffin. To avoid ice formation, drain the water that is
in the tank heater and the internal circuit by qualified personnel.
Cleaning and washing
At least once a week, sterilize the machine by using specific disinfectants, finishing with
repeated rinsing for few minutes. (Filling the tank without overflow is in his seat).
NB: Once unplugged, only authorized personnel can remove the panels.
C. User Manual
39