Casselin CLVAD Mode D'emploi page 35

• The appliance is on the off position.
• The appliance is in regenerating mode.
Selecting the washing cycle
The washing program (short, normal or long) can be chosen by pressing the button A-3.
Each time the A-3 button is pressed the LEDs A-6 light on and off during the selected
program. By pressing on button A-2 the washing pump is activated. A pause of around 5
seconds is activated at the end of the washing.
The washing phase can be automatically extended when the boiler heating element still
heating while the washing cycle is started, the cycle starts but the cycle is interrupted
during 10s before its normal end and will only be restarted when the heating element is
off. The cycle goes on normally with the other phase.
N.B. : if the boiler heating element does not go off, the cycle goes on for a maximal
duration of 8 minutes, then the pause and rising phases are activated, the light A-5
blinks (every 0.3 seconds) and still blinking even if the cycle ends. To reset it the
appliance must be switch off and on (button A-1): the maintenance service must be
called to solve this anomaly.
Extended cycle
To extend the cycle, just press the button A-3 until the light A-6 goes on. Then just press
the button A-2 to initiate the cycle. So far as this cycle is concerned, the maximum
duration is of 8 minutes after witch pause and rising phase go on. You can control
manually the continuous cycle by pressing the button A-2.
If there is a door opening during the cycle.
The cycle will be automatically interrupted when the door is opened. The cycle will go on
when the door will be closed.
NB if the function « soft-start » is on the washing pump is always reactivated on the
same mode.
Regenerating Cycle (optional)
This operation occurs around every 40 baskets (referring to a hardness of 35°C). This
data can change depending of the hardness of the water. Matt marks on glasses shows
the necessity of regeneration cycle. Make sure that there is enough salt in the dedicated
tank (1kg for 5 regenerating cycles)
The regenerating cycle will start only when the appliance is on and its door closed. Then
press the button A-4 at least for 3 seconds. Then the regenerating cycle will go on. It's
when the light A-5 blinks it means regeneration's cycle must be activated. The whole
regenerating cycle takes 21 minutes while the drain pump (if fitted) still activated for
another 20 seconds. The drain pump is automatically off when the cycle ends.
During the whole operation the light A-5 blinks (frequency every 1second)
35