Maintenance - Elica ELG630S3 Guide D'utilisation, D'entretien Et D'installation

Maintenance

I ATTENTION!
Before performing any maintenance operation, isolate the hood
from the electrical supply by switching off at the connector and
removing the connector fuse.
Or if the appliance has been connected through a plug and
socket, then the plug must be removed from the socket.
Cleaning
Do not spray cleaners directly to the control while cleaning
the Hood.The cooker hood should be cleaned regularly
(at least with the same frequency with which you carry out
maintenance of the fat filters) internally and externally.
Clean using the cloth dampened with neutral liquid deter-
gent. Do not use abrasive products. Do not use chlorine base
cleaners.
DO NOT USE ALCOHOL!
I WARNING
Failure to carry out the basic cleaning recommendations of the
cooker hood and replacement of the filters may cause fire risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate
maintenance or failure to observe the above safety
recommendations.
Grease filter
Traps cooking grease particles.
This must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
A
A. Spring release handle
Replacing a LED lamp
The LED lights are replaceable by a service technician only.
See "Who to contact" section in the warranty for service
contact information.
Charcoal filter
When used in recirculation mode, To Reduce the Risk of Fire
and Shock use only conversion kit Models:
Recirculating kit: KIT0141925
Charcoal filter replacement: KIT0141918
If the model is not vented to the outside, the air will be
recirculated through disposable charcoal filters that help
remove smoke and odors.
The charcoal filters cannot be cleaned.
They must be replaced.
The charcoal filters are clipped inside of each metal grease
filter (mounting instructions included with charcoal filters kit).
The charcoal filters should be replaced every 4-6 months
(depending on hood usage).
NOTE: DO NOT rinse, or put charcoal filters in an automatic
dishwasher.
NOTE: Charcoal filters are not included with the hood.
They must be ordered from your supplier.
Order the needed kit specifying your hood model and width
size.
Charcoal filter placement (Recirculating accessories)
Fit the charcoal filter mattress on the upper side of each
grease filter.
Use provided springs to fix it in place.
NOTE: When removing for replacing for a new one do not
remove Fixing Springs, simply pull out one and rotate outwards.
Fixing spring
Charcoal filter
Grease filter
top side
11