Assembly; Assembling The Handlebar And Throttle; Transport Position, Handlebar; Assembling The Cutting Equipment - Husqvarna 343F Manuel D'utilisation

Assembling the handlebar and
throttle
CAUTION! Some models have the throttle handle fitted at
the factory.
• Remove the screw at the rear of the throttle handle.
• Slide the throttle handle onto the right side of the
handlebar, (see diagram).
• Align the screw hole in the throttle handle with the hole in
the handlebar.
• Refit the screw in the hole in the rear of the throttle
handle.
• Screw the screw through the handle and handlebar.
Tighten it.
• Unscrew the knob from the handlebar mounting.
• Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
343F, 345FX, 345FXT
343R, 345RX
• Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that the
machine is in a comfortable working position when it
hangs from the harness.
• Tighten the knob.

ASSEMBLY

Transport position, handlebar

•
•
•
•

Assembling the cutting equipment

343FR, 343FRM
Fitting the blade guard/
combination guard, grass blade
and ball-bearing-mounted support
cup
•
The handlebar can easily be turned to fit along the shaft
for easier transportation and storage.
Loosen the knob. Turn the handlebar clockwise so that
the throttle handle rests against the engine.
Now twist the handlebar around the shaft. Tighten the
knob.
Fit the transport guard to the cutting attachment.
WARNING!
!
When fitting the cutting attachment it is
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is
fitted incorrectly it can result in serious
and/or fatal personal injury.
WARNING! Never use a cutting attachment
!
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
IMPORTANT! If a saw blade or grass blade are to be used
the machine must be equipped with the correct handlebar,
blade guard and harness.
Hang the trimmer guard/combination guard (A) on the
two hooks on the plate holder (M). Bend the guard
around the shaft and tighten it with the bolt (L) on the
opposite side of the shaft. Use the locking pin (C). Place
–
English 51