Cooking In Phases - ETNA CM125HRVS Mode D'emploi

CONTROLS

Cooking in phases

With this function you only need to set the defrost time of the food.
1. Press twice on the defrost button.
'd-2' flashes in the display.
2. Turn the control dial to set the defrost time (maximum 95
minutes).
The display indicates the set time.
3. Press the start button.
The microwave switches on and the set time counts down in
the display. The defrost symbol flashes in the display.
• In order to obtain a better defrosting performance for the
food, turn the dish over during defrosting.
4. Open the door; the microwave switches off.
5. Close the door after checking/turning over, press the start
button and the microwave continues further with the set
programme.
• When the set time has been reached, the current time
appears again in the display, and you will hear 5 beeps.
You can set a maximum of two phases in a cooking programme. If
defrost is a phase in a cooking programme, you should input this
first. A beep will sound when the first phase is ready, the second
phase starts automatically after the first phase.
Example
You would like to defrost food for 5 minutes, followed by cooking
for 7 minutes on 80% power.
1. Press twice on the defrost button.
'd-2' flashes in the display.
2. Turn the control dial to set 5 minutes defrost time.
The display indicates the set time.
3. Press the microwave button.
'P100' flashes in the display.
• Press again on the microwave button to set 80% power.
• You can use the control dial to set 80% power by turning
the dial.
4. Press the start button.
EN 15