Operation - Unold 18540 Notice D'utilisation

OPERATION

1. Remove the kettle from the base.
5. Close the lid until it clicks into place. The locking prevents accidental open-
ing.
6. Place the kettle level on the base in order to establish the contact with the
power connection.
7. Switch on the kettle by pressing the ON/OFF switch downwards into the
„I"-position. The kettle cannot be switched on if it is not properly seated on
the base.
8. Whenever you take the kettle off the base, the appliance is automatically
switched off, even if the water is not yet boiling.
9. The kettle automatically stops heating at the latest when the water boils.
10. ATTENTION:
The automatic switch-off only works, if the lid is correctly closed.
11. Of course you may also push the switch into the „O"-position to interrupt
heating.
12. CAUTION!
Ensure that the kettle is switched off before removing it from the base.
13. Please allow the product to cool down for a certain time before using the
kettle again to heat water.
14. The kettle is fitted with a dry-operation cutout that switches off the heating
elements when they become too hot, for instance when the kettle has boiled
dry. Allow the kettle to cool down. Then fill the kettle with cold water. This
will reset the cutout so that the kettle can be used again.
15. Always use fresh and cold water. Do not leave water in the kettle.
16. Switch off and unplug electrical appliances after use.
Boiling water can cause scalding. Therefore, please handle the appliance
with care when it contains hot water.
The appliance becomes very hot during operation and maintains the heat
during some time after disconnection.
18
Copyright UNOLD AG | www.unold.de
2. Press the opening button on top of the handle. The lid
is released and can be open.
3. Fill the kettle with water (minimum 0.5 litres, mark
MIN, maximum 1.7 litres, mark MAX).
4. CAUTION!
If the kettle is overfilled, boiling water may be ejected!