Technical Information - Electrolux ESI5510LAX Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Problem
The interior of the appliance
is wet.
Unusual foam during wash-
ing.
Traces of rust on cutlery.
There are residues of deter-
gent in the dispenser at the
end of the programme.
Odours inside the appliance.
Limescale deposits on the ta-
bleware, on the tub and on
the inside of the door.
Dull, discoloured or chipped
tableware.
Refer to "Before first use",
"Daily use" or "Hints and
tips" for other possible
causes.

13. TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
Possible cause and solution
• This is not a defect of the appliance. it is caused by
the humidity in the air that condenses on the walls.
• Use the detergent for dishwashers only.
• There is a leak in the rinse aid dispenser. Contact an
Authorised Service Centre.
• There is too much salt in the water used for washing.
Refer to "The water softener".
• Silver and stainless steel cutlery were placed togeth-
er. Avoid to put silver and stainless steel items close
together.
• The detergent tablet got stuck in the dispenser and
therefore was not completely washed away by wa-
ter.
• Water cannot wash away the detergent from the dis-
penser. Make sure that the spray arm is not blocked
or clogged.
• Make sure that items in the baskets do not impede
the lid of the detergent dispenser from opening.
• Refer to "Internal cleaning".
• Refer to "The water softener".
• Make sure that only dishwasher-safe items are
washed in the appliance.
• Load and unload the basket carefully. Refer to bas-
ket loading leaflet.
• Place delicate items in the upper basket.
Width / height / depth
(mm)
Voltage (V)
1)
Frequency (Hz)
Min. / max. bar (MPa)
Cold water or hot water
Place settings
596 / 818 - 898 / 575
220 - 240
50
0.5 (0.05) / 8 (0.8)
max 60 °C
2)
13
21
ENGLISH

Publicité

Table des Matières
loading

Table des Matières