Electrolux ESI5510LAX Notice D'utilisation page 19

Problem and alarm code Possible cause and solution
The program does not
start.
The appliance does not fill
with water.
The display shows
The appliance does not
drain the water.
The display shows
The anti-flood device is on.
The display shows
The appliance stops and
starts more times during
operation.
The program lasts too long. • An energy-saving option has been selected.
The remaining time in the
display increases and skips
nearly to the end of pro-
gram time.
The options of the program
have to be set again every
time.
Small leak from the appli-
ance door.
The appliance door is diffi-
cult to close.
• Make sure that the appliance door is closed.
• Press Start.
• If the delay start is set, cancel the setting or wait for
the end of the countdown.
• The appliance has started the procedure to recharge
the resin inside the water softener. The duration of the
procedure is approximately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
.
authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clog-
ged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the filter in the outlet hose is not clog-
ged.
.
• Make sure that the interior filter system is not clogged.
• Make sure that the drain hose has no kinks or bends.
• Close the water tap and contact an Authorised Service
Centre.
.
• It is normal. It provides optimal cleaning results and
energy savings.
• If the delayed start option is set, cancel the delay set-
ting or wait for the end of the countdown.
• This is not a defect. The appliance is working correctly.
• To save your favourite configuration use option MyFa-
vourite.
• The appliance is not level. Loosen or tighten the ad-
justable feet (if applicable).
• The appliance door is not centred on the tub. Adjust
the rear foot (if applicable).
• The appliance is not level. Loosen or tighten the ad-
justable feet (if applicable).
• Parts of the tableware are protruding from the bas-
kets.
19
ENGLISH