WAGNER AG 14 Manuel D'utilisateur page 5

5. Using the arrow head on the tip handle, insert the
tip seal and tip seal retainer into the back of the tip
guard. Press in for final adjustment.
6. Insert the tip into the slot on the tip guard.
7. Thread the tip guard onto the gun. Position the tip
guard in the desired spraying position and tighten
securely.
NOTE: The arrow on the tip handle should be
pointing in the forward direction for
spraying.
Operation
1. Make sure the arrow on the tip handle is pointing
in the forward direction for spraying.
2. Start the sprayer. Refer to the instructions in the
sprayer's Owner's Manual.
3. Adjust the fluid pressure on the sprayer until the
spray is completely atomized. Always spray at the
lowest pressure necessary to get the desired results.
NOTE: The spray tip determines the size of
spray pattern and coverage. When more
coverage is needed, use a larger tip
instead of increasing fluid pressure.
4. To clear a clogged tip:
a. Rotate the tip 180º so that the arrow on the tip
handle is pointing opposite the spray direction.
b. Trigger the gun once so that the pressure can
blow the clog out.
CAUTION
Never pull the trigger more than once at time with
the tip in the reverse position.
c. Continue this procedure until the tip is clear of
the clog.
© 2005 Wagner. All rights reserved.
Changing a Tip
Tips can be removed and replaced easily without
disassembling the gun.
Never attempt to change or clean the tip or tip
guard without first performing the "Pressure Relief
Procedure."
1. Perform the "Pressure Relief Procedure" described
in the sprayer's Owner's Manual.
2. Remove the tip from the slot on the tip guard.
3. Insert the new tip into the slot on the tip guard.
The arrow on the tip handle should be pointing in
the forward direction for spraying.
Removing the Seal and Tip seal
1. Remove the tip and tip guard from the spray gun.
2. Remove the seal and tip seal from the back of the
tip guard.
Identifying Tip Sizes
To identify tip sizes, use the following formula. A "517"
tip size will be used in this example.
The first digit multiplied by two represents the size of
the spray pattern when spraying 12" away from the
work surface:
5 x 2 = 10" spray pattern
The second two digits represent the diameter of the
orifice on the tip:
17 = .017" orifice
NOTE: Worn spray tips will adversely affect
the spray pattern and result in reduced
production, poor finish, and wasted
material. Replace worn tips
immediately.
5
WARNING
GB
R