Accessories - Husqvarna K 770 Manuel D'utilisation

Equivalent vibration levels, a
Front/ rear handle 300mm (12in.), m/s
Front/ rear handle 350mm (14in.), m/s
Recommended cutting blade
dimensions
Cutting blade di-
Max. cutting
ameter, mm/in.
depth, mm/in.
300/12 100/4
350/14 125/5
Noise and vibration declaration
statement
These declared values were obtained by laboratory type
testing in accordance with the stated directive or
standards and are suitable for comparison with the
declared values of other products tested in accordance
with the same directive or standards. These declared
Sensor for Husqvarna Fleet Services
This product is compatible with the Husqvarna Fleet
machine sensor. The product can then be connected to
Husqvarna Fleet Services
that gives the commercial fleet manager an overview of
all products. For more information about Husqvarna
™
Fleet Services , refer to www.husqvarna.com.
Wheel kit
The wheel kit is attached at the bottom of the product.
Cutting trolley
A cutting trolley makes it easier to cut in floors and
roads, especially long cuts at a set depth. Quick
3
Equivalent vibration level, according to EN ISO 19432, is calculated as the time-weighted energy total for vi-
bration levels in different work conditions. Reported data for equivalent vibration level has a typical statistical
dispersion (standard deviation) of 1m/s
34
3
hveq
2
2
Blade speed rat-
ing, rpm
5100
5500

Accessories

™
, which is a cloud solution
2
.
K 770, K 770 OilGuard, K 770 Rescue
<2.5
<2.5
Blade speed rat-
ing, m/s or ft/min
80 or 16000
100 or 19600
values are not suitable for use in risk assessments and
values measured in individual work places may be
higher. The actual exposure values and risk of harm
experienced by an individual user are unique and
depend upon the way the user works, in what material
the product is used, as well as upon the exposure time
and the physical condition of the user, and the condition
of the product.
™
connections make it easy to install the product on the
cutting trolley.
K 770 SmartGuard
N/A
<2.5
Blade center Max. blade thick-
hole diameter, ness, mm/in.
mm/in.
25.4/1 or 20/0.79 5/0.2
25.4/1 or 20/0.79 5/0.2
1447 - 001 - 16.04.2020