Fracarro SIG7404 Instructions D'emploi page 15

4.5 System settings (1.3 System Setting)
To modify the digits:
press ENTER to change the parameter; use the LEFT/RIGHT arrows to select the digit you want to change; use
the LEFT/RIGHT arrows to change the value; press ENTER to confirm and save the new parameter value.
To modify the parameters:
press ENTER to change the parameter; use the LEFT/RIGHT arrows to select the value you want, press ENTER
to confirm and save the new parameter value.
Enter the 1.3 System Setting menu and enter the value of the bit rate of channel 1:
1.3.1 Channel Bitrat
6000kbps
If necessary, for channel 1, also set Video PID, Audio PID, PMT PID and PCR PID:
1.3.2 Video PID
0x0021
1.3.3 Audio PID
0x0022
1.3.4 PMT PID
0x0020
1.3.5 PCR PID
0x0023
4.6 Select Muxer (1.4 Channel Muxer)
Enter the 1.4 Chanel Muxer menu and enable the output dataflow of the video relevant to channel 1 (Channel
Muxer = Yes). Moreover, set the program name:
1.4.1 Channel Muxer
*yes no
P-Name:DCD
S_Name:Digital TV1
P_Name: provider name.
S_Name: program name.
4.7 Set the IP address (5 Network Setting)
To modify the digits:
press ENTER to change the parameter; use the LEFT/RIGHT arrows to select the digit you want to change; use
the LEFT/RIGHT arrows to change the value; press ENTER to confirm and save the new parameter value.
To modify the parameters:
press ENTER to change the parameter; use the LEFT/RIGHT arrows to select the value you want, press ENTER
to confirm and save the new parameter value.
Enter the 5 Network Setting menu and set the IP address of the SIG7404 module, Subnet Mask, Gateway and
Physical Address:
15