Fracarro SIG7404 Instructions D'emploi page 16

5.4
IP A ddress
1 92.168.000.136
5.3 Subnet M ask
2 55.255.255.000
5.2 Gateway
1 92.168.000.001
5.1 Physical A ddr
2 0-­‐08-­‐06-­‐24-­‐07-­‐01
4.8 General Settings (6 Together Setting)
Enter the 6 Together Setting menu and set the total system bitrates, enable the SDT or carry out the factory
reset (press ENTER to confirm, MENU to exit):
6.1 System Bitrate
027 Mbps
6.2 Insert SDT
*Yes NO
6.3 Factory Config
ENTER or MEUN
5. OPERATION INSTRUCTIONS – PROGRAMMING BY SOFTWARE SNMP
The SIG7404 encoder can be programmed by the SNMP software (CD supplied). Perform the following steps:
Connect the SIG7404 module to the PC through a RJ45 cross cable and launch the executable file contained on
the CD, i.e. 4 INPUT AV MEPG2 Encoder.exe"
The principal page that opens when the program starts is as follows:
16