Automatic Time Limit; Basic Settings; Changing The Basic Settings - Junker JR36DT52 Notice D'utilisation

Automatic time limit

If a hotplate has been switched on for a long time without the
setting being changed, the automatic time limit is activated.
The hotplate stops heating.
indicator flash alternately on the hotplate display.

Basic settings

Your appliance has various basic settings. You can adapt these
settings to suit your own needs.
Display Function
Automatic childproof lock
™‚
Switched off.*
‹
‚ Switched on.
Audible signal
™ƒ
Confirmation signal and incorrect operation signal switched off (main switch signal always remains on).
‹
Only incorrect operation signal switched on.
‚
Only confirmation signal switched on.
ƒ
Confirmation signal and incorrect operation signal switched on.*
„
™Š Time for selecting the hotplate
Unlimited: The last selected hotplate can always be adjusted without having to select it again.*
‹
Once you select a hotplate, you have 10 seconds to adjust it, after which you will have to select it again in order to
‚
be able to adjust it.
Reset the basic settings
™‹
Switched off.*
‹
‚ Switched on.
*Basic setting

Changing the basic settings

The hob must be switched off.
Switch on the hob.
1.
Within the next 10 seconds, press and hold the
2.
for 4 seconds
and flash alternately in the lower display and
™ ‚
the upper display.
Touch the @ symbol repeatedly until the desired indicator
3.
appears in the lower display.
and the / residual heat
" ‰ • œ
@
lights up in
‹
The display goes out when you touch any control. You can
make new settings.
When the time limit is activated depends on the heat setting
selected (1 to 10 hours).
Touch the + or - symbol repeatedly until the desired setting
4.
appears in the upper display.
symbol
Touch and hold the
5.
The setting is activated.
Switching off
To exit the basic setting, switch off the hob with the main switch
and make new settings.
@ symbol for 4 seconds.
21