Automatic Time Limit; Basic Settings; Changing The Basic Settings - Junker JR36DT50 Mode D'emploi

Automatic time limit

If a hotplate is in use for a long time without the setting being
changed, the automatic time limit is activated.
The hotplate stops heating.
hotplate indicator.

Basic settings

Your appliance has various basic settings. You can adapt these settings to your needs.
Indicator Function
™‚ Automatic childproof lock
‹ Switched off.*
Switched on.
‚
Audible signal
™ƒ
Confirmation signal and operation error signal switched off.
‹
Only operation error signal switched on.
‚
Confirmation signal and operation error signal switched on.*
ƒ
Activation of the filament circuits
™ˆ
Switched off.
‹
‚ Switched on.
Last setting before the hotplate was switched off.*
ƒ
™‹ Reset to basic setting
Switched off.
‹
‚ Switched on.
*Basic setting

Changing the basic settings

The hob must be switched off.
Switch on the hob.
1.
Within the next 10 seconds, touch the
2.
4 seconds
™ and ‚ flash alternately in the left-hand display and
in the right-hand display.
Touch the symbol repeatedly until the desired indicator
@
3.
appears in the left-hand display.
Touch the + symbol repeatedly until the desired setting
4.
appears in the right-hand display.
24
and flash alternately in the
" ‰
@ symbol for
‹
The display goes out when you touch any control. You can
make new settings.
When the time limit is activated depends on the heat setting
selected (1 to 10 hours).
Touch the
5.
The setting is activated.
Switching off
To exit the basic setting, switch off the hob with the main switch
and make new settings.
lights up
symbol for 4 seconds.
@