Kenwood KDC-X7000DAB Mode D'emploi page 18

BLUETOOTH®
NUMBER DIAL 1 Turn the volume knob to select a number (0 to 9) or character ( , #,
+).
2 Press S / T to move the entry position.
1
Repeat steps
3 Press the volume knob to call.
VOICE Speak the name of the contact you want to call or the voice command to
control the phone functions. ( Make a call using voice recognition)
BATT LOW/ MID/ FULL * : Shows the strength of the battery.
NO SIGNAL/ LOW/ MID/ MAX * : Shows the strength of the current received signal.
* Functionality depends on the type of the phone used.
Make a call using voice recognition
1 Press and hold to activate the voice recognition of the
connected phone.
2
Speak the name of the contact you want to call or the voice
command to control the phone functions.
• Supported Voice Recognition features vary for each phone. Refer to the
instruction manual of the connected phone for details.
• This unit also supports the intelligent personal assistant function of
iPhone.
16
2
and until you finish entering the phone number.
Settings in memory
Store a contact in memory
You can store up to 6 contacts into the number buttons (1 to 6).
1 Press to enter Bluetooth mode.
2 Turn the volume knob to select [CALL HISTORY], [PHONE BOOK], or
[NUMBER DIAL], then press the knob.
3
Turn the volume knob to select a contact or enter a phone number.
If a contact is selected, press the volume knob to show the phone
number.
4
Press and hold one of the number buttons (1 to 6).
"STORED" appears when the contact is stored.
To erase a contact from the preset memory, select [NUMBER DIAL] in step
and store a blank number.
Make a call from memory
1
Press to enter Bluetooth mode.
2
Press one of the number buttons (1 to 6).
3
Press the volume knob to call.
"NO MEMORY" appears if there is no contacts stored.
2