Kimex 164-5521 Manuel D'utilisation page 89

Command
OPENURL
GETURL
GETUSERAGENT
GETCURSORPOSITION
SETCURSORPOSITION
SETSETTINGSURL
GETSETTINGSURL
SETSTARTURL
GETSTARTURL
Command
SETRC
SETSOURCE
GETSOURCE
GETCOUNTRY
GETSWVERSION
KEY
RESET
STANDBY
BROWSER COMMANDS
Description
Starts the given URL and
returns web page load
status directly.
Gets URL of the current
page if the portal is active.
Gets portal user agent.
Gets cursor position in the
browser.
Sets cursor position in the
browser.
Sets the settings URL
Gets the settings URL
Sets the start URL
Gets the start URL
GENERAL DISPLAY COMMANDS
Description
Enables/disables remote
control commands.
Set source as enable/
disable.
Gets source.
Get country in channels
state.
Returns the software
version of tv.
Send key to Eclipse.
Reset the device.
Switch display to hard
standby.
(Note: Don't use this com-
mand with the product
that has OPS. You can
use other "KEY standby"
command.)
English - 27 -
Parameter
string-integer n <load
url='n' />
no parameter
no parameter
no parameter
string-integer a,b
string
no parameter
string
no parameter
Parameter
string-integer n (n = ON, n
= OFF)
"string n, integer b (n =
SCART1, n = SCART2, n =
FAV, n = SVHS, n = HDMI1,
n = HDMI2, n = HDMI3,
n = HDMI4, n
= YPBPR, n = VGA, n =
SCART1S, n = SCART2S) (b
= 1(enable), b = 0(disable))"
no parameter
no parameter
no parameter
string-integer n (n = 0, n = 1,
......, n = up, ......, n = menu,
.....ext.)
no parameter
no parameter
Return
#*status= ... url=n
#*URL : ...
#*Current UA : ...
#*X: ... Y: ...
#*X: a Y: b
#*Setting URL is set
#*Setting URL is ...
#*Start URL is set
#*Start URL is ...
Return
set remote state On or set remote
state OFF
"#*Selected source n
#*Enable/Disable state : b"
#*source is ...
#*COUNTRY IS : ...
#*V...
n key send to Eclipse
Reset process was successfully
accomplished. You need to
establish the connection again.
"#*enterLowPowerMode() returns
successfully.
or
#*enterLowPowerMode() returns
unsuccessfully!
or
#*enterStandbyMode() returns
successfully.
or
#*enterStandbyMode() returns
unsuccessfully!
"