Kimex 164-5521 Manuel D'utilisation page 86

• RS-232 (female) to RS-232(male) cable or LAN
cable (connected via router)
• USB to RS-232(male) cable
• Notebook or PC which has USB or LAN port
• Installed program on remote PC to send commands:
In general, the RS-232 commands are sent for
operating the implemented functions via serial port
and utility. A suitable utility can be used such as
described below.
Secure Commands
This feature is controlled by the Secure Command
profile option. If option is enabled, all commands will
be registered as secure.
If this profile option is disabled, commands can be
run without having admin level, otherwise user must
have ADMIN level privilege.
Currently there are 2 modes for user: NORMAL and
ADMIN
For switching user to admin mode, use the following
command:
SETUSERSECLEVEL ADMIN <password>
This setting is not permanent, and will be set to default
(NORMAL) again in case of restart.
Connecting to the Display (LAN port)
Download and install the PuTTY software from the
following link first: http://www.putty.org/.
Run the software and enter the Display's IP address in
the field Host Name. Enter "1986" as a default value
in the field Port. Then select "Telnet" as Connection
type and click the Open button.
Note: Refer to the Connectivity section of this manual for
information on connecting the Display to a network and
displaying the IP address of the Display.
Use the commands in the RS232 Command Table.
For example, if "GETVOLUME" command is entered,
current volume level should be displayed on the putty
window as shown in the pictures below.
Another example;
Volume level can be changed by using "VOLUME"
command. After sending this command, you can verify
the changes from the Display.
The last example ;
When "GETSOURCE" command is entered, current
source should be displayed on the putty window as
shown in the picture below.
Connecting to the Display (RS232 port)
Run the software and select Serial as Connection
Type. Enter the Display's serial port in the field
Serial Line (in the following example it is COM4)
and "115200" in the field Speed. Then click the Open
button.
English - 24 -