System Features; Federal Communication Commission Interference Statement - Kimex 164-5521 Manuel D'utilisation

System Features

Panel
Panel type
Resolution
Horizontal
Visual
angle
Perpendicular
Max. brightness
H-Frequency
V-Frequency
Audio
2 x 8 W Audio Output Power
Network Connection
Ethernet (LAN) for Internet connectivity
802.11 a/b/g/n built in WIFI Support (optional)
Input/Output Ports
1 x USB 2.0 port
1 x USB 3.0 port
1 x Internal USB 3.0 port
2 x HDMI 2.0 In port (1.4 for FHD panels)
1 x HDMI Out
1 x VGA port
1 x Audio input port
1 x Audio output port
1 x RS232 port
1 x RJ12 port
1 x Video In port
1 x YPbPr port
1 x SPDIF Coaxial Out port
1 x Headphone port
1 x IR port
OPS
Up to 40w
Power
110-240V AC 50-60Hz 1A
Weight (kg)
18.25
Display Dimensions DxLxH (mm)
709 (H) x 1236 (W) x 69 (D)
55" (139cm) 24/7 ELED
1920x1080 FHD
89°
89°
Typ: 400 cd/m2
60 Khz
67.5 Khz
English - 40 -
Wireless LAN Transmitter Specifications
Frequency Ranges
2400 - 2483,5 MHz (CH1-CH13)
5150 - 5250 MHz (CH36 - CH48)
5250 - 5350 MHz (CH52 - CH64)
5470 - 5725 MHz (CH100 - CH140)
Country Restrictions
This device is intended for home and office use in
all EU countries (and other countries following the
relevant EU directive) without any limitation except
for the countries mentioned below.
Country Restriction
General authorization required for outdoor
Bulgaria
use and public
If used outside of own premises, general
Italy
authorization is required
In-door use only for 5470 MHz to 5725
Greece
MHz band
General authorization required for network
Luxembourg
and service supply(not for spectrum)
Radio transmission is prohibited for the
Norway geographical area within a radius of 20 km
from the centre of Ny-Ålesund
Russian Fed-
In-door use only
eration
5 GHz band only for 5180 MHz-5320
Israel
MHz range
The requirements for any country may change at
any time. It's recommended that user checks with
local authorities for the current status of their national
regulations for 5 GHz wireless LAN's.
Warning
Surges could cause data loss except monitoring
modes.
Federal Communication Commission
Interference Statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful in-
terference in a residential installation. This equipment
generates, uses and can radiate radio frequency ener-
gy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is en-
Max Output
Power
< 100 mW
< 200 mW
< 200 mW
< 200 mW
service